Question Locked

New Build: setting up SATA drive and optical drives

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just got a new ASUS motherboard and am building a new system. I have only 1 SATA WD hard drive, no IDE hard drives, and two optical drives. My question is :
Do I set up the optical drives on the primary or secondary IDE connector on the motherboard. My understanding is the primary IDE is only for bootable hard drives, is this correct? Also, is there any advantage to set up a single Sata HD in a raid configuration? I thought you always needed at least 2 identical HD to set up a raid configuration? Thanks for any advice.
Markey

2 replies

by hal 9000

[i]Do I set up the optical drives on the primary or secondary IDE connector on the motherboard?[/i]

Doesn't really matter though I would personally set them to the Secondary IDE Channel it's not really important. But you may need a Floppy Drive to install the SATA Drivers as that is the only option given to you when you attempt to install the SATA Drivers if required in the Windows Setup Installer.

[i]Also, is there any advantage to set up a single Sata HD in a raid configuration? I thought you always needed at least 2 identical HD to set up a raid configuration?[/i]

No but you may be getting a bit confused here with the ASUS Drivers as all the SATA Drivers are held in the RAID folder of the CD ROM and you need to copy the one that you actually need to the root of a floppy to install it.

There is also no advantage of using any form of RAID on a single drive as it would slow down the read/write speeds to the drive as you would need to divide it into 2 identical Partitions. Even then I'm not sure if it would work as a RAID because I've never been silly enough to try something like that out.

Col

This discussion is closed to new replies.