2 replies
by tombb Accepted solution
by hal 9000 Accepted solution
Some NB's have an adaptor that goes from the HDD to the M'Board make sure that this has been replaced quite often things like this are missed and without any contacts being made the HDD can not be seen.
Also look at the jumper if there is one on the old HDD and set the new Drive the same way as the old drive was set so if you have a jumper on the new Drive and the old didn't have one remove it and if the new one doesn't have a jumper on it shorting out 2 pins pull the one off the old HDD and place in on the same pins on the new drive.
Also check the connections to make sure that the HDD is actually plugged in properly and the obvious one is to make sure that you have the right type of drive to begin with.
You may also need to look at the size of the replacement HDD as if it's much bigger than the drive that came out of the system the Systems BIOS may not recognise the new HDD because the BIOS doesn't support that size HDD.
Col
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending