Question Locked

New System...

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently did a computer upgrade. I purchased the following: Intel Core 2 Duo e6600, Gigabyte GA-965P-DS3 rev 2.0, Corsair XMS2 1GB DDR2 800 (PC2 6400) memory (2gigs total), PnY 7300GT PCI-E. The only thing not new is the HD, 80gig maxtor. The system will start up normally, post but then gets stuck in a restart loop. I run WinXP Pro SP2. It boots, posts, but after intial post, I get a screen for like 1 sec stating error, then it restarts. I do not get the XP startup at all. Any ideas what is going on? When I put the (OLD) system back, it starts up just fine, no errors. Totally confused here

5 replies

by dumphrey

you switching systems? Just switching hard disks? Was the XP Pro a clean install on that machine? What is the old system that works? Can you start the XP Pro in safe mode (f8 on boot)?

by jesus_c

after the rebuild then that is you problem.Too much of a hardware change for the system to handel

by mr.wiz

You probably don't have the drivers for the new hardware on the old drive. A clean install would probably be the best, less chance for problems. If not, try F8 and see if you can load the drivers for the new stuff in safe mode.

by cechevarria

okay, ya the only thing that was not NEW is the HD. I will try it out tonight thanx yall.

This discussion is closed to new replies.