Discussion Locked
0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have AMD NIC (PCnet FAST) onboard Gateway E-1000s. Recently we upgraded the management software on our Synoptics Management Modules for the 10bT concentrators. Now the AMD NICs will not connect to the network through the concentrators. So far the only fix we've discovered is installing 3Com NICs in each machine, but we will not be able to do this for every PC. Has anyone run across this problem, and what was the fix used? Does anyone know of manual settings for the E-1000s' AMD NIC?
9 replies
by dixon_fe
Try this PDF document (http://www.amd.com/products/npd/techdocs/20550.pdf) provided by AMD. It's a huge document (265 pages), but it does have configuration information in it. Hope this helps.
Thanks for the direction to the PDF, but it's a developer's technical reference. Unfortunately, it doesn't have the Win9x driver's control settings (at least not that we could find).
by mphoffar
The manual will probobly have your answer via some sort of reg key, but I wonder if this is something as simple as looking at the nic properties in the network applet and manually setting the NIC to 10BaseT there.
Mark
We've read that the settings in the Network control panel is supposed to control the speed via the TP value, but changing this has not helped (tests on working PCs has disabled networking altogether). We've also tried working with the duplex settings to no avail. As for a manual, my only guess is that since it is a built-in NIC that is "supposed" to be PnP, no mention of specific settings (outside of BIOS settings) was included in our documentation.
Update: We have found the manual configuration settings in a tech manual by Gateway...unfortunately, the PCnet chip used is not supported by AMD, so the diagnostic software will not work. We have been able to rule out the networking client (all networking clients cause excessive collisions) and we are currently looking into the possibility that the hardware is incompatable.
by burtsa
Look at the settings for the network card under network properties. Check and see if your cards have a setting for Threshold I have found some cards that if this is set to anything but "Store and Forward" the card is unreliable.
Hope this helps
Shawn
The driver we had (from Gateway) did not have the Threshold setting, and AMD listed the chip as "unsupported." We kept looking until we finally found the absolutely newest driver for the chip (well hidden on AMD's site), which did give us new settings under the Networking Control panel, but the collisions on the Synoptics concentrator continue to shut the system down. We can only conclude that the problem in an unresolvable hardware conflict between the Synoptics (Bay Networks) networking hardware and AMD. Thanks to all who tried to help.
This question was closed by the author
The driver we had (from Gateway) did not have the Threshold setting, and AMD listed the chip as "unsupported." We kept looking until we finally found the absolutely newest driver for the chip (well hidden on AMD's site), which did give us new settings under the Networking Control panel, but the collisions on the Synoptics concentrator continue to shut the system down. We can only conclude that the problem in an unresolvable hardware conflict between the Synoptics (Bay Networks) networking hardware and AMD. Thanks to all who tried to help.
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
0 helpful
1 reply
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies