Discussion Locked

No fixed disks present

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I try to "fdisk" a hard drive it gives me this message. "No fixed disks present" I think I have troulbe shot everything? help!

15 replies

by paul.chalkley

Have you checked the cables to your HD. Does the drive spin? Is the drive IDE or SCSI? Check to see if the Bios (or SCSI adapter card) can detect your harddrive. Does your Bios suppourt your HD size?

by todd

The above answers are the first steps, but...
if you have a bootable disk, and a virus scanner disk, you may want to check for a virus.

by philthegreat

No fixed disks present (i.e. fdisk is not present)
Your windows (I assume windows 95/98) must have problems; so copy one (fdisk) from the original CD or from your friend.

But for safety sake, an re-installation over the present one (to keep the original setting) may be used.
But a clean re-installation is better.

by raymond.caldwell

I'm assuming you checked the BIOS, but also depending on the manufactuer of the HD, you may have to play around with jumper on the drive as well, since some drives (like Seagate) have finicky settings Ex: DS,CS...stuff like that.

by wgirid

Hi!
What's the setup here? One hard drive only on the IDE channel? Check:
1)BIOS - autodetect HD; is a drive found?
2)If no autodetect capability (old computer), you must enter drive parameters manually.
3) Is IDE controller (IDE drive assumed) enabled (this is #1, really)?
4) Still no drive detected? Check all cables that they are firmly in place and pin 1 orientation is OK.
Regards
/WGIRID

by compute2u

Not alot Of Info(left the system line blank}.
If you have or added a second drive/cd-rom. remove the slave and see if the drive is found. The jumpers may be set for the same drive or one may be on cable select.
And again tonight, if windows 98 is being used make sure the the harddrives LBA in BIOS is disabled/off.

This discussion is closed to new replies.