Question Locked

no floppy a drive on laptop.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
while downloading a copy of xp i recieve the message: setup did not find any hard drivers installed in the computer. I do not have a floppy drive.

5 replies

by robo_dev

you mean when installing XP, correct?

What kind of computer do you have?

Many different brands of SATA controllers are not included with the XP install disk.

If you use an OEM Windows install disk for your PC, it should have the drivers.

The SATA driver issue typically happens only with XP or XP SP1, so if you're loading XP SP2, it has a very good inventory of SATA drivers on it.

What you need to do is:

a) get a USB floppy drive and copy the required SATA drivers to a diskette.

-or-

b) get an OEM Windows XP CD for your PC.

-or-

c) Get a XP SP2 CD versus what you've got.

-or-

c) 'Slipstream' the SATA drivers onto a Windows XP install CD. This is a bit tricky.

http://www.seasonsecurity.com/sata-drivers-for-slipstreaming-into-windows-xp-sp2-installation-cd-for-acer-aspire-5100-32203

by brian

...Setup said it found no HARD DRIVES... Most likely if it is a newer computer, you need to enter the BIOS and change the hard drive setting from AHCI to IDE (windows vista and 7 use AHCI)...start there and see what happens...if that doesn't work, then more informaiton will help, make/model of computer, original os...etc...the post above may also be another step you need to take.

by oh smeg

So it doesn't have the necessary SATA Drivers included in the Install Media. If you need to include these you need to make a Slipstreamed Install Disc and include the System or M'Board Makers SATA Driver.

To do this you can use nLite which is available free here

http://www.nliteos.com/download.html

Just do not forget to read the Instructions listed under Guides for the way to use this software

http://www.nliteos.com/guides.html

Col

by oldbaritone

During the boot of the Windows install CD, it pauses for a second with the message "Press F6 to load additional drivers"

Do that. Then insert a CD with the drivers for your SATA hardware. Load them, then windows will ask for the original disk back. You'll probably need to swap a few times during the install process.

Or alternatively, try BIOS configuration and see if your HDD controller has an IDE mode. Set it for IDE, install windows, then load the upgraded SATA drivers and the manufacturer's driver will switch the controller to SATA mode during boot.

This discussion is closed to new replies.