Question Locked

No projector signal once windows boots

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I currently have a machine running WinXP with 2 video cards. From the 2nd video card, I have the VGA cable connected to a 1:2 VGA hub to output to 2 projectors. All was working well until a few days ago when the projectors showed no signal. I checked all connections and then rebooted the machine. I noticed that both projectors display the POST boot up screen and the WinXP logo, but once Windows is booted, both projectors seem to lose signal. I'm at a loss as to what may be the problem? Could it be a bad video card or the 1:2 Hub? Should I try System Restore? Any suggestions are greatly appreciated.

Thanks,

Jon

5 replies

by thumbsup2

Try just one projector at a time, plugged directly into the computer. Then, try the other. If both work on a stand-alone basis, the hub has gone bad.

If neither work, look in the device manager and make sure the 2nd video card has not been disabled. You said you could see POST, but when Windows starts, nothing. It could be a weak card or corrupt drivers. Can you hook a 2nd monitor to it? What do you see when you go into display properties. Can you extend the desktop to the 2nd monitor?

---

by jonatay325

I'm at work now, so I can't try anything yet. However, I do not have a 2nd monitor connected, but I can say that the desktop does extend to the 2nd monitor (or what would be). Thanks for the suggestions, I will try them tonight.

by jonatay325

So I disconnected the 2nd monitor cable from the computer and connected it to my laptop and both projectors including the hub are working fine. So it's obviously an issue with the computer. Now, It only has 1 video card, Radeon X1300 with dual outputs. I tried plugging the monitor into output and 2 and its a black screen, but I don't get the typical loss of signal error on the monitor. I then updated the driver. A new one was just posted today. Still no change? Do I have a bad video card?

by jonatay325

I don't know what had been changed, but I decided to go ahead and do a System Restore and they immediately started working again. All is well. Thanks for the suggestions.

This discussion is closed to new replies.