Discussion Locked

No Windows NT Domain Controller

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Everytime I restart my PC, I always got an error that says "No Windows NT Domain Controller is available for domain ... ".

But when I log off then log back in, I don't get the error message anymore. Meaning, the error message appeares only right after a restart. Please help.

Thanks,
Chris

11 replies

by robert schommer

I would check the binding order of my protocols and also to see if any uneccessary protocols are starting, possibly delaying the start of the protocol used on your network.

by ardinescc

Our PDC has only one protocol installed, TCP/IP. And from our workstation, TCP/IP is already at the top on the binding order.

by dc1

Make sure that all of your protocols are configured correctly. Also make sure that there is nothing wrong with the NIC that you are using and that the cabling is good.

by ardinescc

File/printing services have no problem, hence, the protocols and NIC are setup correctly and calbing is verified ok.

by dcadmin

Try going to server manager, remove the computer from the domain and then add it back. Wait a few minutes, restart your pc and then try and login.

by bhrdwh

Use only one protocol in your NetworkNeighbourhood. I use only TCP/IP. Remove NetBeui, IPX etc. Also make sure you start your PDC first, login into it, then start your DHCP Server, then start your client systems.
Akash

by ardinescc

NetBeui is not installed. IPX is being used for your Novell Server. All other PCs have the configurations, but only this particular client has this kind of problem.

by bhrdwh

I suggest you check it for Tweak or Power Utils. As you say, if its a case of just one workStation, I suggest you reinstall it & ad it to your domain. Problem gets solved easily.
Akash

This discussion is closed to new replies.