Discussion Locked

NT 4 FAULT TOLERENCE

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I install NT 4 Server which has 5 drives ntfs formatted. When I try to use fault tolerence the options are grayed out. I am loged in as admin. I wanted to use mirroring or stripe with parity..Thanks for help

6 replies

by magetower

To be able to activate a fault tolerance scheme the drives involved (other than the system disk) needs to be unpartitioned space. The scheme you select will create the correct partitioning and allow you to format with NTFS.

by magetower

You will also need to SHIFT-click on all the drives you want to use to select them before choosing a fault tolerance option.

Good luck

by ian mclaws

As the previous answer says, you must control select all drives before the create stripe set is available. You must be running SCSI (since normal IDE only allows 4 drives). Are you sure you have 5 drives, and not 5 drive letters (partitions or logical drives). In order to implement NT 4.0 RAID, you must use multiple physical hard drives.

Good luck,

Ian

This discussion is closed to new replies.