Discussion Locked
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I install windows NT . The files are copied to the harddisk and it restarts.Then I get a message crash Debug and to contact the system administrator.how to overcome this.
1 reply
This could be caused by incorrect SCSI or IDE drivers.
If so when it says "setup is inspecting your hardware configuration" press F6 and have your IDE or SCSI drivers handy.
Also try using a boot disk, create a 2 Gig Fat16 partition (not Fat32), then copy the entire contents of the I386 directory from the CD to a folder(call it i386 as well) on the 2 gig partition.
Then go into the directory on the C drive
Type
C:
cd i386
then type
winnt /b
If it still bombs at this point it may be a driver issue or it may be that some of your hardware is not on the HCL (hardware compatability list).
Good Luck.
James
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
2 helpful
22 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
16 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies