Discussion Locked

NT 4.0 BSOD(Blue Screen of Death).

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I install windows NT . The files are copied to the harddisk and it restarts.Then I get a message crash Debug and to contact the system administrator.how to overcome this.

7 replies

by bhrdwh

You already have NT on it ?, I suggest when you install NT, choose "format drive" & then proceed. Also check the Lan card & other devices with HAL. If you are installing NT on a fresh system, I dont see no reason that you get the blue screen.
Akash

by jkeller

When the BSOD appears write down the 0x000000XX(0x00000000,0x00000000,0x00000000) numbers that appear at the top. Go to Microsoft's Technet site(microsoft.com/technet) and run a search through the knowledge base. Use the first set of numbers to search(0x000000XX). There are many articles in there concerning this issue.

by valachi

I don't know if this helps you but I wanted to share a stupid experience with a stupid NT server. It was using a SCSI controller that seemed to be recognized. After the first step, after copying the files and rebooted, the computer would crash. I checked the Hardware Comp. List - the controller seemed to be there. "Seemed" because it wasn't: the model was differing from listed on by only a letter! As soon as I installed the controller's driver - (F6 - additional mass storage devs) it installed.Check message. If it is something containing STORAGE, there it is. It's really stupid - you think that if NT was able to copy the files to the HDD, this is recognized by NT - actually is using another driver to access the HDD in the copying stage than later.
Also, there is a good article in Technet - Q126690 - that describes installation errors in NT and how they can be overcomed.
Good Luck!

This discussion is closed to new replies.