Discussion Locked

NT 4.0 only sees 8gb of 40gb hdd

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a server that has a 40 Gb Ide Hdd now the server sees the drive fine. However when I install NT 4.0 server it only sees 8 GB of the drive. It did say that it was a drive that had more then 1240 clyinders however the main board disk does not have IDE dirvers.

Can some one help me. I have installed Service pack 6a but this did not help.

9 replies

by craig haunch

The boot partition for NT can only be maximum of 8Gb. I would recommend only using a 4gb boot partition. Once NT is installed you can then go into admin tools, disk administrator and assign the rest of the drive to a data partition, so you end up with a 4gb boot partition (where nt and apps are installed) and a 36gb data partition. Hope this helps.

by cavedweller

In addition to SP6a you might need to update your BIOS. Some older BIOS had an 8GB limitation. I had to update a couple of my Dells when I added new disks.

by tomsal

First, don't give me any points..Craig provided the right answer, not me. I'm merely here to tell you that he's right in what he said. To hopefully build your confidence in his answer.

NT is limited to 8gb boot part...but you can add additional partitions. Btw, its for security reasons that the 8gb boot limitation is there. Also, in theory (I say in theory because no computer on earth has yet to have this much storage - this includes Super computers) --- NT can support 16 Exabytes. That's 4,000 GB x 4,000 GB. ;)

Pretty big huh? Damn...imagine a game using that space? LOL..

anyway..later.

by daveyuen

Yes, Craig is right but 1 more thing. Depends on which PC you r using, if you r using a Pentium II which Mainboard support 500Mhz or lower, you have to update the bios cos for those computer, they can only recongize no more than 25G HD whatever how big is you HD.

This discussion is closed to new replies.