Discussion Locked

NT 4.0 Password

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I cannot find find the local administrator password for a windowsNT 4.0 server, is there any way I can get a new administrator password without re-installing the server? I would appreciate an answer, urgently.
Thank you
Phillip

8 replies

by ian_c

If the server is still on a domain and you have domain admin rights, you can change the local admin password from a command line, using:

net user Administrator

Otherwise you'll probably need to install an additional NT server andcrack the password using LophtCrack or something.

by rabbit_runner

Hi,
This problem has a simple solution. If you do not have the domain administrator password, there is still a solution.
1. Re-install NT into a DIFFERENT directory. I assume that the current installation is c:\winnt. Install into a DIFFERENT dirrectory (this is VERY important. You are keeping your current installation SAFE, but installing a new version to a different directory.
2. You will give an administrator a new password in the new installation.
3. boot your computer to the NEW installation of NT. (do not worry about drivers, software, etc. you will not need them)
4. When at the desktop of the NEW installation, open the following folder c:\winnt\system32
5. rename the file LOGON.SCR to LOGON.BAK
6. rename the file usrmgr.exe to LOGON.SCR (sounds crazy, but this really works)
7. Shut down and re-boot to the ORIGINAL installation of NT.
8. Get to the logon screen, and leave it alone for about 20 minutes.
9. What will happen, is the logon.scr screen saver will activate, and you will have the user manager on the screen.
10. Find the administrator user, and change the password to what you want.
11. Shut down and reboot to the ORIGINAL NT.
12. at the logon screen, log in as administrator.
13. DO NOT FORGET to rename the files listed above, back to their original names.
This really works, even on a domain controller. I have done it several times and it works fine.

best of luck

by rabbit_runner

An extra note.
On #8. do not touch the keyboard, and do not move the mouse. you want the screen saver to activate.

by c. hilbrandt

If you do a parallel install, as suggested by Mr.E, but instead of changing the login.scr, delete the SAM database on the first installation. Boot into the original load and the administrator password will be blank. Obviously this isn't a good option on a PDC or if you have a lot of user accounts that aren't easily recreated. Generaly on a member server, it isn't much of an issue. If your original NT Load is on a FAT partition, then you could boot up on a DOS disk, and delete the SAM database.

This discussion is closed to new replies.