Windows Forum

Ask something
Discussion Locked

NT 4.0 Ras error 1066

0 helpful
5 replies

by razorren

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I installed RAS on my NT server for dail-in only (TCPIP & NETBEUI). However I'm gettin a error in my event viewer saying..
The Remote Access Server service terminated with service-specific error 1066.

The Remote Access Service is not configuredto receive calls, or all ports configured for receiving calls are in use by other applications.

Any suggestions. Thank you.

Renrick

5 replies

by avachon

Hi, this error - 1066 - is noted in microsoft's knowledge base article: Q106204.
The basic reasons for this error are: server not set up to receive calls; problems with the modem; com port not enabled in the bios; com port not available - in use byother application. Obvious troubleshooting - go back into ras properties and make sure settings are correct (for example, correct modem if more than one, etc.); also may want to check authentication level (if other than clear text, try clear text and see if you can get it working). Reapply service pack if not done when ras was set up. Hope these suggestions help you. More details on how you set up ras on your server would be helpful.

This discussion is closed to new replies.