Discussion Locked

nt 4.0 sp6 server manager problems

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

trying to set up my server. i have a hp 900 mhz 256 ram 40 gig hd. i got the software all installed nt4.o sp6. when i go to
server manager it says network path not found select another domain and i
type the computer name in and it goes in, but it will not go in with domain
name. and when i try to add to domain it is dimmed out? i cannot access it from workstation either. is there a file or some sort of backup i can do from old server which we are still using while i set up new one, thati could copy to new server to get all settings the same. i have gone through and set up all the tcp/ip and etc.., the same as the old servers...please advise me on
what to do ? thanks

8 replies

by lordinfidel

It sounds like wither a problem with that computer being registered in the domain or make sure your connected to the network physically. Check connections and cable.

But some questions first. I am assuming that this is not a PDC or a BDC.

Is it a member server to the domain or is it a standalone no domain membership.

Can you get out to the net or can you ping other machines on your network?

Some things I would try. Remove that computer account from the domain thru svr manager on another machine.

On the server itself change it's membership from domain to workgroup. Press apply. It should say welcome to workgroup.

Do not close out. Then join it back to the domain (it should prompt you for a user name and password). Ifit says welcome to the "xxxx" domain then press ok and Reboot.

If this still does not work reapply the service pack.

Also some other things to look at. Open up svr mgr on another machine and change your view to servers only. Is the machine there?

Plus, did you use the same name for the new machine as the old?? That will be a definite problem because of the SID.

Also i know that this sounds rote. But immediately after you installed svr you installed SP6, then your drivers and software then reapply the service pack.

hope this gives you some clues.

by hotrodgers

this is a pdc, and i cannot get any network connection. the old server when you go into server manager goes directly in and shows the domain, the new server will not go in the server manager it says network path not found? i put same dns #'s in new server setup like the old ones is that right and how do you decide what ip#'s to use?
thanks
steve

by hotrodgers

this is a pdc, and i cannot get any network connection. the old server when you go into server manager goes directly in and shows the domain, the new server will not go in the server manager it says network path not found? i put same ip #'s in newserver setup like the old ones is that right and how do you decide what ip#'s to use?
thanks
steve

by hotrodgers

this is a pdc, and i cannot get any network connection. the old server when you go into server manager goes directly in and shows the domain, the new server will not go in the server manager it says network path not found? i put same ip #'s in newserver setup like the old ones is that right and how do you decide what ip#'s to use?
thanks
steve

by estebandelatorre

Your choice of upgrading your PDC was wrong. If you do not have a BDC:
Remove all accounts from server manager
Join every machine again to the new (different machine name) domain
If you have a BDC:
Promote your BDC to PDC from server manager
Format HD and install it as a BDC of the current domain, then promote the BDC to PDC

This discussion is closed to new replies.