Discussion Locked

NT Install-Can't find hard drives

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to re-install NT4 Server and get a message that NT setup cannot find any hard drives. We have two mirrored HD's which I broke the mirror on prior to running setup.
These are 18G SCSI drives. What am I overlooking??

Thanks!

Phil

7 replies

by rachel_s

If you are running the setup from the floppy disk, during the setup boot process it will detect the IDE or SCSI controllers and the CD Rom and disk drives. If it is not doing this, you may need to obtain a driver for the SCSI card. There will be aplace in the process that confirms the controllers present. If you do not see your SCSI card listed, you will need to add it by using the driver at this time. Adaptec cards shouldn't give you any problems. I first would check to make sure your diskettes aren't bad.
From the CD Rom is simmilar unless you are using a DOS based boot diskette. I would try to delete any partitions through fdisk if possible (NTFS partitions can be difficult if you had multiple partitions). Then try again.
If this does not work, watch the boot process closely to check the SCSI card and drives are being seen fine during the boot process before it goes to the CD or floppy drives.

by themain

I concur with rachel_s.
adding to what was said though,
first boot a floppy and check the partition info. it should show non-dos partitions if NTFS was used. you did not mention whether or not they were recognised by fdisk. a windows 98 boot install disk with scsi option is one way to 'see' the drive.
is the scsi on the motherboard ? or add in board ?

check your BIOS settings to see if there is an option to boot to scsi, cdrom, in that order so the machine will be looking for a scsi drive. when it cannot find a bootable scsi drive it will seek the nt install cd and will ask if you have any drives other than IDE. this is where you will choose the non-default option so the driver disk can be supplied for the scsi drive from the floppythat comes from the manufacturer.
if this fails then drop in am IDE drive and set up NT / sp6a then hook up the scsi drives . use NT's disk management to format the drives. for inside NT you may be able to install to the scsi drive.
hope this is your remedy !

by joshg

I believe there is a known issue when installing NT when using the CDROM. If you are installing from CDROM without the setup disks when NT detects the hardware it may not detect SCSI HDD's. To correct just boot with the setup floppies. If you don't have them you can make them from the CD.

This discussion is closed to new replies.