9 replies
Check with the supplier and he will help you..
If you have the CD and you can boot from it then you can go ahead and install windows NT, but before check with the supplier regarding this.
Good Luck
by knibbg
by drfox
If you have the NT CD you are able to create the start up disks.
Insert the CD and open up a command prompt.
Locate the I386 folder on the CD and type the following WINNT /OX you will need 3 disk I think but it will tell what is required.
Hope this helps
David.
by knibbg
by it tech
by knibbg
by awdfg
If you have Windows 95/98 installed then run the file "autorun.exe" from the "i386" directory of your Windows NT4 CD and the installation will begin.
If your BIOS supports booting from CD Drive then you can boot with your NT CD and the installationprocedure will start automatically.
Make sure that the size of the primary partition(C Drive) is not more than 2GB.
If your hard disk capacity is greater than 8.4GB then it is better to use fdisk(take a backup of important data) and create primary partition of size <= 2GB and install Win NT and Service Pack >= 3 and then create the required partitions from the remaining disk space using fdisk.These partitions can then be accessible in Win NT and you can do a quick format on them also.
by knibbg
by knibbg
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending