Discussion Locked

NT not starting

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My NT Workstation stopped at the blue screen and froze. There were no error messages. Restarted the machine and it did the same thing. Checked system bios, all appeared fine. Restarted the machine with the WNT start up disk and ran the EmergencyRepair Disk. The machine then made it all the way to the log on. When I tried to log on, got the blue screen 'beginning dump of physical memory.' Restarted the machine, it ran chkdsk, all reported fine, booted all the way to the log on screen, butagain at log on the same physical memory dump screen. If left, the machine goes to the log on screen and then restarts all on its own. Any suggestions?

11 replies

by liquidcoolit

Have you installed any new hardware ? Have you installed new drivers for hardware you currently have ? check that. remove any of that hardware you might have just installed and try reboot. Also try run "Last known Good configuration" which will bootthe config you last were able to log onto the machine succesfully (pressing F8 at bootup will give you that option). And then have a look at event logs and see what errors might have come up there. Also in the Blue screen, look and see what Device driver is showing at the top of the screen, that would give you an indication of what might be causing the problem.

by cruncher_1

My suggestion is to take off the cover and reseat all the connections to the hard drives and mobo. Good Luck.

by mcmunt

Read the top couple of lines of the bluescreen for any hints. Maybe you might see it's pointing to HW drivers of some sort. At the end of the day it could be something like dodgy RAM or just corrupt boot files. Time to grab that backup . . . .

by chinl

Need a bit more info. Did you install any new hardware and driver. If so remove or replace it if it is essential (ega vga)with another type of card. The computer should start with errors and look in the logs to see what is causing it.

Stop the offending service, making sure you have not stopped an essential service. Set it to manual or disable it and then restart the computer.

by nla467

first try starting the ws in VGA mode and right click on My Computer select properties and startup/shutdown tab and uncheck the Automatically reboot option. read or print out the dump file and check which driver or apps are failing.

good luck

This discussion is closed to new replies.