Discussion Locked

NT Printing to Remote LAN

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Does any one have any suggestions for printing to a network printer in a remote LAN without a file server?

I currently have 19 remote sites (250 users)without any file servers, 3 regional sites with a file and print server, and 1 corporate site with several servers.

My remotes sites are connected via a 56K line so I want to avoid routing print jobs over the WAN. I also want to make client configuration as easy as possible. I don't want users to have to configure IP addresses on printerports on their PCs. I don't have any local tech support in any of the remote sites.

I have about 70 printers in the field that are printing Unix jobs. I'd like to utilize them for NT printing also.

Thanks,

Mark

5 replies

by curious_george

You have not mentioned whether or not the remote sites each have local network printers on their LAN, nor have you mentioned client OS (NT??) I'll assume so for both..

If one primary requirement is to allow simple client config then you need an NT print server, period. However, you could assign a high end workstation at end remote location that duty if money is a problem with implementing a real server. I suggest installing a remote control SW on all remote systems since you have no remote techs. I use VNC when security requirements are modest, because it is lite and fast and FREE. Additionally I have written scripts to install it and run it from any NT or W2K system to any other NT or W2K system. I'd be glad to forward my scripts to you if you want them. Email me at david.a.stewart@kodak.com if you want to play with it.

You could use the remote control software to configure the remote print servers and workstations w/o leaving your desk.

Good luck.

by mdotson

This is the solution that I was already considering, but I'd like to find an actual Print Server/Spooler to attach to the remote LANs.

I do have network printers in all the remote sites and the client OS is WIN95/NT. I appreciate the suggestions.

Thanks, Mark

This discussion is closed to new replies.