Discussion Locked

nt server hard drive not recognized

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm running nt server with service pack 6 on my removable HD. one day, the hd doesnt boot up. it displays an error that says "hard disk failure" or something like that. its not even recognized by my computer in the cmos (detect hd). what is the problem?
corrupt mbr?if so, how do i fix? yohayon@hotmail.com

11 replies

by jwilczyn

Try to change the IDE cable. Than try to change to 2nd IDE connector on the m/b and detect in CMOS. If you can detect HD - it may be software corrupted, if not - bad luck - your HD is dead.

by nskharade

I agree with the first answer but would like to add that also check the power supply of the hard disk

by cavedweller

Go to the BIOS setup screen. Does the disk in question show up? Try to auto-detect it if it doesn't. If the BIOS sees the disk continue with the other advice.

by toms

if you hold the drive in your hands, with the power connected, and turn on the computer, can you feel ther drive spinning? if not the platter may be stuck to the heads, try the following:
1) disconnect all cables from drive.
2)hold drive between hands, as if praying, with one hand on top and other on bottom.
3)make sure you have a good grip and then rotate your hands forward and then back towards you. Do this hard and several times.
4) plug the power back in and fire it up. Does it spin now?
if not sounds like the board is toast. good luck!

by hari19580

CHANGE YOUR IDE CABLE AND CHECK IT FOR CMOS AUTODETECT HDD. ANOTHER WAY PUT YOUR HDD IN OTHER JUMPERS LIKE PRI. MASTER, SLAVE OR SEC. MASTER, SLAVE, AND CHECK IT FOR AUTODETECT HDD.

This discussion is closed to new replies.