Discussion Locked

NT workstation can't find NetWare server

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Our office uses a NetWare 4.11 server and NT 4.0 workstations (and domain). A newly installed workstation finds the NT domain without problem, but can't "see" the server. (I have installed the Novell client for NT/2000.)

9 replies

by ttierno

This is more something to look for than a sure answer. Assuming that you are connecting to Netware with IPX/SPX, you may want to try locking down the IPX frame type to 802.2 (or whatever 802.3 if that's what is bound to your server). I have seen this failure with the NT default frame type of "auto" and some NICs.

by dcassat

While you're locking down the protocol you might also manually setting the network number. I remember that you double-click on the network card once you're in network properties.

by bohicam1

The frame type for netware 4.11 and earlier is 802.3 but that shouldn't be the issue here as you are not using different frame types. Have you checked to see if NWLINK is installed on your new workstation?
right click network neighbourhood icon, choose properties and see if it is in the list. If it is not, on the same screen, click add/protocol/NWLINK let it install, reboot and that should take care of it. I am assuming that there is no NT server on the domain? If there is, then that is not your problem either as you would be accessing the netware server through that. You might also want to check to see if there is an account setup on the netware server for your NT workstations, the new one might have to be added to the group.
Good luck!

Mike

by steed

Right click on Network Neighborhood, Configuration and make sure Novell Netware Client is selected as the Primary Network Logon. Check the IP addsess and subnet mask are OK. Next, ping the server. You might need to reboot for changes to take affect of course. If you get a response from the ping
Re-install netware client just incase it missed a file on the first attempt (that happened to me last week). If this doesn't work you will need to give me a little more info but it sound like it will besomething simple - nothing to do with frames etc.

This discussion is closed to new replies.