Discussion Locked

NT workstation can't lease IP address

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have NT workstations (4.0 sp5) that can't lease ip addresses from a DHCP server in one subnet but are able to do so from a second subnet. The subnets do not share the DHCP server.
I have used the ipconfig /renew/release several times to no avail. Any ideas

7 replies

by dchrista

Sounds like an incorrect gateway entry. Change entry to correspond to correct subnet, reboot, and an address should be correctly release from the appropriate DHCP server.

by nettek

Your question isn't very clear to me. Did you create a scope for that subnet on the DHCP server?

You don't say if your subnets are across routers. If they are, did you tell the DHCP server the IP address for the router under DHCP Options? If you are trying to retrieve addresses across a router, you should be aware that DHCP lease requests are done by broadcasts, not point-to-point IP. To eliminate unnecessary network traffic, routers don't normally route broadcasts. To enable routers to route broadcasts, the routers must be RFC-1542 compliant, must support BOOTP forwarding, and must have BOOTP forwarding enabled. If you are unable to do this, make one, and only one, NT Workstation on the subnet a DHCP relay agent. Network Neighborhood -> TCP/IP -> Properties -> DHCP relay tab. Add the IP address of the DHCP server. The NT Workstation will now listen for lease requests on the subnet, convert them to a point-to-point IP communication right to the DHCP server, retrieve the lease, and send it to the client. The down sides are that the NT workstation acting as a DHCP relay must be turned on, and some of its processor power will be consumed by acting as the relay agent.

by bryan_hartman

If your on a large network it could be possible that your out of ip addresses for that segment. You are limited to 255

This discussion is closed to new replies.