Discussion Locked

NT4 / Win98SE network config

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How TO: existing NT4 Workstation network config is Netware, how do I change this so I can connect to to a separate computer with Win98 Microsoft Network file and printer sharing? Or, where do I locate absolutely correct instructions on this process? ASAP

10 replies

by avachon

Hi, well, first of all you can connect to the 98 machine using microsoft's implementation of ipx/spx - choose novell instead of ms network and file sharing in the network applet of the 9.x machine. However, if you would prefer to get rid of nwlink (ms implementation of ipx/spx) on the nt machine, go to the network applet (right click on network neighborhood and hit properities or access it through control panel). Then you can add to the protocol list - you can choose tcp/ip for example or netbeui (fast, small but not routable). tcp/ip is more complicated and both machines need to be running the same protocol (so you'd need to set up tcp/ip or netbeui on the 9.x machine as well). After you add the protocol you want to the nt machine, you may choose either to keep nwlink or remove it. If you don't need/want it, remove it. You'll be prompted for your nt disk (and 9.x) when installing protocols and you'll need to reboot. I suggest you also reinstall your service pack for nt. There are lots of articles to step you through this is you need more information: ms knowledge base and technet (http://www.microsoft.com).

by beefhead

After you try the first response (ipx/spx required for this step)
Try installing Client for Novell Networks from : Control Panel ? Network ? Add (button) Client - Manufacturer: Microsoft
That should make the shares on the 98 PC available to theNT system. (If that is the direction that you want to go??)

An Answer to go .....

Beef

by beefhead

This applies to the 98 machine. Since I am assuming that you would rather reconfig 1 machine as opposed to the whole network.

by wolffster

Since you need to connect to the Win98 machine, there are a couple of things you need to do to the NT Workstation (forget about the Netware services...)

1) Make sure that they both belong to the same Domain or Workgroup.

2) On the Win98 machine, under network properties-->Configuration, make sure you have installed the Client for Microsoft Networks. If not installed, NetBEUI should install as well when installing the Microsoft Networks client.

3) On the Win98 machine, under network properties-->Configuration, make sure you have also enabled the computer to be able to share files and/or printers. This is in the file and print sharing button.

Once these settings are in place, the NT Workstation should be able to browse to the 'computer name' sharing the printer (or files).

If you cannot see the other computer, then there may be browsing issues which could easily be solved with a registry change. Windows has a registry key to control browsing issues. Either way, in a Microsoft Networks environment you need to make sure the Domain or Workgroup name matches in both computers and that file and print sharing is 'enabled' (not just installed) on the computer sharing resources.

by wolffster

PS- The no brainer... you have to share something first in order to see it across the network.

This discussion is closed to new replies.