Discussion Locked

NT4.0 Failed Update

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When trying to correct a driver problem on an NT4.0 server, I tried to update the operating system using the distribution CD. All went well until the machine rebooted. It produced an error message and a memory dump. Turns out the original problemwas fixed another way but now every time I reboot the server, the failed upgrade show as a boot option (eg: normal boot, boot with VGA, boot with the upgrade). I can select the normal boot but How Do I Get Rid Of The Failed Upgrad Boot option? Thanks

5 replies

by plg6

Hi.

From the start button Go to settings-->control panel. From there click on "system". Click the tab "Hardware Profiles" Highlight the bad one, hit delete and out it goes. If you only have two profiles, you'll now just have one, which will become the default and therefore work automatically. Note too that you can change the amount of time to select a boot option on this screen also.

by rludwig

We checked the hardware profile and there was only one entry, labeled "Original Configuration". Thanks for your quick response.

by mjchekal

I would just remove the entry in the boot.ini, this file should be in the root directory of the boot partition. By default it is set to read only. If the unit is trying to boot from that also you will have to edit the default line to reflect the location of the proper boot files

This discussion is closed to new replies.