Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Installing NT 4.0 Server with netbeui people can log in. I install TCP/IP on the server and no one can log in. Remove TCP/IP and it works again. WHY?
3 replies
by churdoo
Could be from one of two things .... do you have a service pack installed? If so, have you reapplied the service pack after installing TCP/IP? If not, there is one possibility.
The more likely reason, though, I suspect has to do with the orderingof your protocols. Go into the networking properties / Bindings / select All Services / expand Server / find the protocol that people will most likely be using to log into the server and move that higher than the other. You will need to reboot after doing this, and then try. Do the same for the NETBIOS service.
--Charlie
by russ werner
You also didn't mention anything about ip numbers or subnet mask. Try using 192.168.0.1 for your NT computer and have each of the others use 192.168.0.2 , .3, .4, and so on. Have the 255.255.255.0 as the subnet mask for all computers. When this is done try pinging the ip numbers from each of the computers.
by duglorsam
was using that exact IP scheme already - thanks tough!
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
17 replies
0 helpful
5 replies
0 helpful
12 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
14 replies
0 helpful
2 replies