Discussion Locked

NTbackup

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running NTbackup for backup on NT4 SP6a. However, I cannot start the application. I see that it is an active process but it will not let me terminate the service. (Access is denied). Any ideas?

8 replies

by fenaikh

Hi
pls check that there is a tape in the tape drive it usualy do that if a job running and no tape in the tape drive.

good luck

Mohamed

by dcassat

This occurs when the backup application detects an error like missing tape but usually occurs when using the scheduler to schedule jobs. If this is the case, you need to add the /interactive switch to the schedule line for the job (in the batch file). This allows the system to display an error instead of hanging.

If this is not the case, I've not seen it before but I can tell you the only way I've found to end the backup process is to reboot the server. My research at the MS web site confirmed this.

by jesperm

I have had a similar problem,

I was trying to run the backup.exe from the SP installation/backup folder and not from it's propre location c:\winnt\system32\ntbackup.exe

So re-booting the server and running the file looks to have cleared the problem.

This discussion is closed to new replies.