Discussion Locked

NTFS Partition

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a 15G hard drive 13G's are NTFS partitioned I want to install WIN 98 on the entire hard drive how do I acomplish this?

12 replies

by cmurphy-mcse

To accomplish this you will need reformat you harddrive with fat or fat32. then you would be able to install win98. If you want to use nt with 98 as a dual boot machine you would not want to use fat32 because nt is not compatible with it.

hope this helps

by pan 13 x

remove the partition and format the entire drive with fat32.(win98 can not read ntfs). you can remove the partition with fdisk.
once format with fat32 you can install win98 with no problem.

by frobo

Hi,

win98 starts only from the first Partition, this Partition must be Fat in order to install win98. If you want to change partition?s in size or order you can use a tool like Partition Magic , with this tool you can change the partition?s on your Drive without to reinstall NT. But be careful and save your Data on this Drive first, and make an NT-boot disk for quick recovery. If change the Order of your partition the boot.ini must reflect this changes in order to start Nt properly. You can test this best with an NT boot disk containing your actual Boot Files( boot.ini,Ntdect.com and NTLDR) . Create an NT Repair disk with RDISK ?S.
Once you created this disk test it immediately. After it you could change the arc path to boot your NT. After you installed your win98 system on C the NT-System would not boot any more, and this is right. Win98 has got overwritten the Masterboot sector and the Bootsector of your Drive. Now you need to ?repair? your NT-Bootfiles, just start form the NT ? CD and press ?R? for Repair an existing installation of NT 4.0 and follow the instructions. Be shure the point for repairing the SAM is unmarked (!!!!!). The only thing we care about are the Bootsectors. To repair an MasterBoot record you have to start an fresh NT install and abort it after a few minutes. (Yes, you have to clean up a :Boot.ini a little, deleting some Folders like $instnt?$)

You could install third Party tools for Fat32 support under NT, but MS won?t support that.
Depending on how worth your NT-installation is, sometimes a complete new installation would be faster. The normal installation order is : 1. Win98 and then NT 4.0 (, w2k Pro, Linux , ?.)

Hope you enjoy this

Regards

Frobo

by frobo

I mean, your need two disk: one Nt-Boot disk and a second Disk for Rdisk.

by dirk.richter

Let's keep it simply.

You should remove the NTFS partition. You do not have to, now but it helps. Then you should boot from the Win98 installation CD (Booting from CD has to be set in the BIOS!). When setup starts you choose the whole disk to be formated in Fat32.

Hint: With partition magic you could preconfigure your system before you start the installation or even afterwards but this tool is not for free.

by izz

With fdisk try to change the active partition and then boot from a bootable floppy disk and enjoy setting up Win98. Then you will have to modify the boot.ini file so as to make it a dual boot.

Hope it works

This discussion is closed to new replies.