Discussion Locked

Of mice and Mouse

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Have recently replaced my mouse (microsoft ps2 with roller) with a compatible A-4Tech mouse two button. No drivers came along with it. Here's the Question :- when the system is booted up each day everything works fine except the mouse pointer is stuck. When the system is restarted it recognises the mouse and unfreezes it. Why does is recognize the mouse the second time round and not the first time?

7 replies

by tbradley

check in settings-control panel-system-device manager to see if you have more than 1 pointing device listed, and delete any that are not present in the system.

run sysedit at the start-run prompt, and check to see if any dos mode mouse drivers have been loaded in the config.sys or autoexec.bat files ... ie mouse.sys or mouse.com and remove them if there are.

Check in settings-control panel - mouse to see if the scroll feature is still enabled. You did say you went from a scroll mouse toa 2 button right?

You also might want to install a generic ps2 mouse in add new hardware, and remove the microsoft mouse.

by jacklr-ups

If you look in the device manager on a normal boot, you may just see one mouse driver. However, if you boot into safe mode and look at the device manager, you may have two or more mouse drivers. Removed all the drivers, then restart and Windows should install a single working mouse driver.

by shawnyong

Go to System Properities and disable to the mouse not in use. Reboot your PC, Windows will recognize the mouse the first time round. Ring the Bell?

This discussion is closed to new replies.