Question Locked

overheating computer

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently bought a computer to put in my new desk, to my dismay it keeps overheating, air gets blown out the back, hits the back section of my desk, which has a 9cm gap down the bottom, then pushed back in through the side.

I have looked around and the best I can find is a fan to attach to the expansion port on the back of my computer. So I was wondering if anybody knew of a product that would allow me to attach a fan to one or two 5 1/4" bays, or any other means of cooling (that isn't overly expensive).

4 replies

by nicknielsen

If air-flow (or the lack of it) is your problem, here are some questions/suggestions in that area. In no particular order:
- Can you reduce the ambient temperature around your computer desk?
- Is the gap you mention in your post the only opening into the area containing your PC or is there a complete flow-through air path in the enclosure? Opening a door/drawer or installing an intake vent may improve matters.
- Has debris (books, papers, etc.) piled up around the sides of the PC? Is there at least 2cm clear all around the case?
- Is the PC set on a hard surface? A soft surface under the PC may inhibit airflow through the under-case vents.
- Have you considered building a deflector to put on the fan exhaust on the back of the PC to direct the output downward toward the aperture?

by thechas

Your problem is not in getting air into the PC, but in removing the hot exhaust air from the back of the desk.

Further, drive bay fans alone will not make a significant difference. First, they do not move a lot of air. Second, you do need to have cool air flow over the GPU, CPU and out the power supply. Drive bay fans may help cool the power supply. But, might change the airflow such that other devices have little or no cooling.

If nothing else, I would look at installing a fan in the desk to suck the hot air from the back of the PC out of the desk.

Alternately, you can try a couple of air flow control tricks.

First, make a cardboard baffle so that the intake on the side of the case draws the air in from the front.

Next, position the PC such that there is at least a 2" gap between the back of the PC and the desk.

Finally, you need at least a 40 square CM opening for the hot air to exhaust.

Chas

by mjd420nova

First you need to make sure that all the fans in the unit are clean and vents are free of dust build up. Creating an area on the front of the unit to draw in fresh air helps things run cooler when the intake is forced to draw in its own exhaust. Working with pieces of cardboard to direct air flow and dressing up the cables inside to allow air flow over the critical areas helps the unit to run cooler and more efficiently. Try to remove any obstructions in the exhaust area and blocking exhaust from being drawn back into the unit will decrease the temperature considerably.

This discussion is closed to new replies.