Discussion Locked

Pagefile.sys

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Where should I place the pagefile? We have a pagefile that is 1GB that is currently on a raid-5 configuration of that has pretty high disk read/writes. These drives run at 5400 rpm's (connected via differential scsi) yet the local drives which have the NT 4 loaded on run at 7200 rpm's. Any recommendations?

3 replies

by nettek

Because NT has is constantly conducting I/O traffic to the system directory, it is always better to place the the largest portion of your pagefile on a partition other than that which holds the system files. You should have some of the pagefile on your system drive, because when NT conducts a data dump it needs to dump it to the %systemroot% directory. Your best solution is to use the default/recommended pagefile size on the %systemroot% directory, and place a second pagefile on your raid array.

As far as speed is concerned, think about how RAID 5 works. If you have an array of 5 disks, and you page an 8mb file to the raid array, you have 2mb saved to each of the five disks (8mb data + 2mb parity = 10mb; 10mb / 5 disks in array = 2 mb per disk. This happens SIMULTANEOUSLY. Would you rather save an 8 meg file to one disk running at 7200 RPM, or would you rather save 2mb on 4 disks at the same time at 5400 RPM?

by matt.walker

Thanks for the input. The only reason why I brought this up was because of the amount of I/O traffic on the external raid. I needed another opinion to confirm what I was already thinking.

This discussion is closed to new replies.