Windows Forum

Ask something
Discussion Locked

Pakistan quake relief network printer

0 helpful
1 reply

by johnbarryiii

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to put an HP Laserjet on my network. I have it cabled into a foundry switch, I do not get an activity light on the switch, do get a light on the jetdirect card. Cable is known good, when I print out the configuration page i notice "I/O Card Not ready" "LAN Error - Loss of carrier"

1 reply

by winterfrost

I've seen similar link problems when the device is having a problem auto-negotiating a connection speed. Can you set the link speed on the port to 10 or 100 MBit?

This discussion is closed to new replies.