5 replies
I have seen this happen before and as a matter of fact it happened on one of my machines just the other week after an electrical storm. There are probably other answers but in my case the setting in the system BIOS got set to disabled for LPT1. When you start your machine enter the BIOS/CMOS set-up. How this is done differs from machine to machine. For some of them when the machine starts to boot you hold down F2 and other use the Delete key and still others use different keys. When you start your machine it should tell you the key or key combination to use to enter set-up. Once in set-up go though the menu items and on one of the screens you will find a setting to enable or disable LPT1 (the printer parallel port). If the option isset to disable you found the problem. Read the instructions, usually at the bottom of the screen, and set the option to enable and then save and exit the system. When you re-boot the port should automatically return.
Changing the settings can be a little cryptic if you have never done it before. Some of the set-up programs require you to highlight the option you want to change and then press the plus key on the numeric keypad. There are many variations. It is not difficult but you have to read the screen and be careful. Don't change anything that you don't understand or don't know what it is. The BIOS/CMOS settings program can be a very dangerous place to roam and the settings can cause major problems with the machine.
This is only one answer to a problem that probably has many causes and different answers. Hopefully we have identified the cause of the problem and this will help.
Good Luck,
Erwin
by justinc
by robbinsr
by justinc
by justinc
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending