Discussion Locked

Parity or non-parity

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
On old systems, (30 pin SIMS and 72 pin SIMS)How can I tell the diference between one that uses parity memory and one that uses non-parity memory

9 replies

by richard_barsby

Hi you could try going to the manufacturer of the SIM modules web site, or on older SIMS if there are 9 chips it is a parity type, if there is less than 8 then it is harder to tell. If the main board you are using has the option to turn off parity checking of the memory I think both types will work, I hope this helps.

Best Regards

R.K.Barsby

by dmiles

You can check the CMOS control panel and select the second column concerning and down the list you will see a column whether the memory parity is enabled or disabled.
You can't use nonparity memory in a non-parity system.Hope this helps

by spiceman

sorry - no way of telling except by trial and error. If you know you have one parity module it should pair up with another module with same.

Manufacturer web site sometime have details on type of memory and parity. Memory parity must match usually in pairs and also the speed e.g 60ns or 70ns or what ever

by burtsa

In general when you look at the simms there are either an odd amount of chips this typically means parity because the memory chips come in 2 varieties 1 bit or even bit 2,4,8,16,etc..

Even amount of chips mean non parity for the same reason. because chips come in the 2,4,8,16 bit varieties

Hope this helps

Shawn

This discussion is closed to new replies.