Discussion Locked

PC shuts down during boot

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

An old PC (PII 233 Mhz) does not boot up properly. It beeps, start to boot, but it shuts itself down about a minute. The monitor claims it gets no signal from PC. (This happened some time ago, but when the PC had started and windows was up and running the screen started up)
I suspect the powersupply is not function properly or the grafic card. Any suggestion?

5 replies

by thechas

If this comes and goes, the power supply would not be my first suspect.

Does the PC shut down, or does the monitor just go blank?

If the monitor just goes blank during boot, you might want to try booting into safe mode, as you may have a mis-match between the video driver and the monitor.

If the PC actually shuts down, check the following:

Does the MB have 72 pin SIMMs for memory?
If so, check if the SIMMs and sockets have the same plating color. There have been corrosion issues with mis-matched plating on the SIMMs and sockets.

Otherwise, remove and reseat all cards and memory modules. Over time they tend to work loose a little bit, and can cause problems.

Also, check that the connector for the monitor is secure to the video card.

by thechas

Okay, since the PC actually shuts down, there are 4 primary suspects;

The power switch; more apt if this is an AT style system.

The power supply itself.

The power connector on the motherboard.

The power supply control circuitry on the MB; ATX only.

Beyond the above, it reaches the point where it is more time and trouble than it is worth.

If you have another power supply available, it would be worth swapping the supply to check it out.

by den dydige

Thx.
That is what I suspected. I will try to switch a power supply if I can find one spare, but I think I'm better off buying a new full tower cabinet.
Now I can tell my wife that I tried to fix it :-)

This discussion is closed to new replies.