Discussion Locked

Peer-to-peer network setup

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

What is the best way to set up a peer-to-peer in the home environment with 4 PCs?
Can this be done with TCP/IP using 127..., 10..., or other? Will using these IP addresses interfer with outside communications to my ISP and others?

Thanks for the info

3 replies

by ann777

The best way to proceed is to purchase a broadband router (dsl/cable router/firewall with 4 or 8 ports). Connect your computers with cables from your nic to the router and from your isp connection to the router. This provides Internet sharing. The ip addresses you use on the "inside" will not matter, the router will do NAT (network address translation) and all your ISP will see is the IP address of the router (the "outside" IP).

If you have a modem connection to your ISP, then you'll need to look into other alternatives. You will need to purchase a hub and connect to the hub. Win98 and above comes with software called ICS (Internet Connection Sharing). You will need to go to Control Panel and verify whether ICS has been setup. ICS will work with modem setups.

by petemcc

If you just need 1 pc connected to the internet you?ll at least need a hub. If you are using a cable modem for web access you?ll should set up two NIC?s on the host machine, one for web access and one for LAN. Install netbeui for your LAN if having multiple connections to the internet is not a concern and you won?t have to worry about TCP/IP settings. But if you are doing this for study go ahead and set up TCP/IP and ICS. ICS is built into 2000 and is accessed through network properties. ICS will assign a 192.168.0.*** address to the client machines. It will work regardless of how you are connected to the internet, modem or otherwise, you just need to have separate interface for each connection on the host machine. Make sure obtain IP address automatically is set on the client machines. I started out my home LAN with cable modem hooked to the uplink on a 4 port hub with 3pc?s on the other ports ,later upgraded to 2k server, added a second network card and set up NAT.

Hope this helps,
Pete

This discussion is closed to new replies.