Discussion Locked

pinouts on COM1(9 pin) and on PDA

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I would like to build a serial cable between my PDA (PALM IIIe)and my PC COM1 (9pin)
I would like to know about the pinouts which is which PLEASE HELP me
Eventualy please tel me which are the pinouts in a serial com1 port i will find out the rest

7 replies

by dmiles

Pin 1-Carrier Detect
PIN 2-Receive Data
PIN 3-Transmit Data
PIN 4-Data Terminal Ready
PIN 5-Signal Ground
PIN 6-Data Set Ready
PIN 7-Request to Send
PIN 8-Clear to Send
PIN 9-Ring Indicator
DTE TURNS ON THE DTR
DCE Acknowledges this message by turning on DSR
DTE Turns on its RTS
DCE Acknowledges this request with a CTS
DTE-DATA TERMINAL EQUIPMENT
DTR-DATA TERMINAL READY
DCE-DATA COMMUNICATIONS EQUIPMENT
DSR-DATA SET READY
RTS-REQUEST TO SEND
CTS-CLEAR TO SEND

by mosh

Hi
Search TechRepublic or TechProGuild, there is an article on this subject

Mosh

by vinnyd

Answer #1 has what all the pins outs are.
This is how to wire the cable.

PC PDA

2 to 3
3 to 2
5 to 5

Wire on the PC side
Pins 1, 4, and 6 together.

Wire the same pins (1,4, & 6) together on the PDA side also.

This discussion is closed to new replies.