Windows Forum

Ask something
Discussion Locked

Pleading HELP!!!

0 helpful
7 replies

by agriffx

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i have pentium 100 48megs of ram and 2 half gig harddisks. I was told the reason the cd-rom will not work is because the drivers for the i/o card its connected to are gone. the cable will not connect to my primary storage drive but will to secondary. Should i try and slave it off or can i find these drivers? The i/o card is Sun moonstar and it was connected to designated SOny. Thanx

7 replies

by mphoffar

Best place I've found for Drivers is www.windrivers.com. They also have a ton of cd-rom drivers there, if you need to load your cd-rom that way.

In all actuality though, it'll probobly be easier to slave the drive and go from there, or spend $40dollars and get a new controller. And yes..I have seen ISA controllers still new at a lot of stores.

Mark

by stngfan1

If your MB supports 2 IDE channels, Put it on the second and make it slave. Make sure it is active in the bios. Why add a I/O card if your MB has it already.

by philthegreat

Find it in www.google.com or Sony
But I think you can use a generic driver too; but Sony may need a specific one;
But your win95 should recognize it and install the driver.

This discussion is closed to new replies.