Discussion Locked

pnp/pci slots

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I would like to know how to reset the configuration of the pnp/pci slots on the mother board. I have tried to reset it through the bios setup in "pnp/pci configuration " menu. did not work. want to reinstall a card and cannot due to previous installation. I would like windows to detect new harware automatically as it does when the slot is first used.what do I do to get the slot in the unused state?

11 replies

by th

You need to remove all entries for the card in Device Manager and you need to locate the (.inf) file associated with the card and remove that as well.

by teknik

Try to remove the cards first
then enter pnp bios setup
select automatic configuration
save bios
power off the machine
install the card.
power on the machine
if it doesn't work try to install the card in another slot.
good luck

by burtonizer

As answered above, you want to "uninstall" the card and all existing software related to it ~ reboot. Once you reboot, make sure there are no references to the card and shut down. Put your card in and boot up ~ Windows should find your card the way it did before. If you want to point it to a specific driver file, you may want to copy that file to a subdirectory first that you can point to either during installation, or after the card is in you would go into device mgr. and click update drivers pointing to that subdirectory. good luck!

by dark force

Remove the card, then boot Windows into "Safe Mode" by pressing F8 when you see "starting Windows 9x". Go into Device manager and remove all the listings for the card you wish to replace, Power off and reinstall the card. Windows should see the card as a new device. If it still doesn't, use the ADD NEW HARDWARE 'Wizard'.

I have found that Windows keeps several versions of the same device that can only be seen in Safe Mode when none of the drivers are loaded.

Good Luck

by big ray

You could start by looking at the INF file on the driver disk. Check the Windows\INF\ folder and move the file with the same name to a backup directory. Then remove the software and reboot. Windows will then look for the inf in the folder not be able to locate it and then ask you for a driver location. This does not always work though. If it doesn't, copy the old inf back to the original location and then follow these steps.

I have found that windows remembers which slot a card is in. We had this problem on windows 98 w/ a 3com sc905B-TX ethernet card. The solution we found was to remove the software and then the card. Plug the card into a different slot. When the computer reboots it would then say that it found new hardware and would ask for a location for the drivers. Cancel the install and after shutting down return the card to the original slot and when powered up windows will now ask for a driver location.

This discussion is closed to new replies.