Discussion Locked

Printing problem in Windows NT Server

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am Network Administrator in Nirma Institute of Technology. Our server has windows NT o.s. One printer is attached with this server. Now, when I am giving print command, it is giving message that "Network Name was not found. Error writing to LPT1 "
I have reinstall the drviers also. in control panel it is showing that parallel port device is started. If I boot the server in PC-DOS Mode then it can print. But it can not print in GUI Mode.

7 replies

by Member 26066076

Hi,
Your problem is common with most printers connected to Nt Servers.
Here is a checklist of things:
1. Make sure you have the correct drivers, the ones supplied by the manufacturer, and not given by Microsoft. Also, they have to be specific to Windows NT only.
DO NOT USE Win98 drivers here.
2. If you are trying to print remotely, make sure you have made sharing permissions on the parallel port printer. If you are a user on the server, MAKE SURE you have been given permissions to print using this printer.
3. Make sure the parallel port connections are correct, sometimes the printer could be conected by the network card.
4. In the System Settings, goto Printers, and print a TEST PAGE, so that you can make sure the connections are fine.

Good Luck. Mathew

by travkinlaw

first make sure that your parallel settings are correct, DOS will use a minimal/simple amount of resources- just the opposite of NT.But, go to a dos prompt from within NT, and type use the "net use" command to connect to lpt1- if this does not correct the problem, then it will be the drivers or your service pack is not compatible with your printer.

by dell196

Some older programs require a persistent connection to print. Open a command prompt and type net use: lpt1 /persistent yes.
The exact syntax might be a little different for you. Hope this helps.

This discussion is closed to new replies.