Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am Trying to get maximum throughput printing on a NT 4.0 SP 6 machine. The type of printer is an HP 8100.I have the 8100 PCL 5E driver loaded and I can get approx. 15 pages/minute. With the 5si drivers loaded i can reach 20 pages/minute To get maximum throughput on this type of printer you need to run ECP. Unfortunately ECP is not supported in NT 4.0. If anyone has any suggestions for this it would be great.
3 replies
Hi
A couple more things you can try (depending on your environment) are:
1) use the postscript driver - it may be faster depending on what you are printing
2) ensure you have the printer properties on the NT 4 machine set to the correct amount of memory for the printer, and look at other options available in that window too. For example you may want to prevent font download or enable spooling.
3) try connecting the printer and workstation to the network, and set up as a network printer.The bandwidth through the network may be greater than through the parallel port.
HTH
William
Poster rated this answer
This question was closed by the author
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies