Discussion Locked

problem with Ethernet card

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,
I've installed an SMC 1211TX Ethernet card in order to connect to my flatmate's PC.
The card was installed with no problems, no questionmarks or anything in the Device Manager.
If i recall well, when i previously was using a network the Orange LED at the back of the card was blinking when there was no cable attached and it was constantly on when the cable was attached.
Now, none of my LEDs are on!!! , and i get a Cable unplugged warning from windows even when the cable is attached.
The card is sharing IRQ(11) with 3 other devices but there are no conflicts.
I'm using a new driver from SMC.
This card was previously working, again in Win2000.
Can you think what can be wrong ?
Thanks a lot

9 replies

by sluggo210672

A few things to look at:
1. Is the driver you are using for that particular network card and not some other one.
2. Is the card seated correctly.
3. Have you had any power spikes.(Card could be damaged)
4. Has the card ever worked properly
5. Are you plugged directly into yor friend' computer and are you using a cross over cable.

Failing that, take out the card and get rid of its drivers and references from the Device Manager. shut down and restart and check to make sure that the changes have taken affect. Shut down again, insert the NIC and restart. Let Windows detect the card (if it can) and use the drivers for the NIC card.

That is all I can think of off the top of my head. Hope it helps.

by dcosgrove

There are two things I would check first. Appropriate cable as mentioned above. Crossover is need for direct link, straight through if using a hub. Also, it is very esy to get a cable that has a bad connection or is miswired. Try another cable and see if it helps.

by espet

Im not sure if this will help, but I have had problems such as you describe when I share IRQ's. You mentioned that you are sharing with three other devices on that IRQ. I would think this could be the problem. Try reasigning the IRQ.

by estebandelatorre

Leds should be ON only when the cable is connected.
1.- Attach another pc to this cable in order to check that the network cable and switch is working properly.
1.a.- Another PC works fine. This confirms that your nic may be damaged or bad installed.
2.- Remove the card driver from your pc, remove the nic card and start all over again. Be sure to use the correct driver that, not only works in w2000 but matches the nic specifications labeled in it.
Some old cards need a DOS config program in order to set properly the IRQ DMA and connector type. Some of them included some testing software, try it.
IRQ 3 & Memory #300h or #320h are the usual default values.

1.b.- Another PC does not work. This indicate that the hub/switch or cable system may be damaged. Replace the cable or simpley plug another pc to the hub or switch using a different cable.

Good luck

This discussion is closed to new replies.