Discussion Locked

Problems geting second monitor working

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have just loaded win 2000,I tried then installing the second vga card and to figure the second monitor, but i get a question mark on the second card, The drives have all being loaded, If i swap over the monitor cables itworks fine. I use a dual boot system with win 98 and the two monitors work fine WITH WIN 98. i am totally bambooseled, can any kind person help,much appreciated
Thank you
Norman

7 replies

by roland63

it is quite obvious there is a CONFLICT with the second card.

Make sure there are no conflicts - remove and uninstall the card. Make sure your pc boots up ok without the second card THEN put the card in a DIFFERENT SLOT and give it another try.
Good luck.

by poettone

You have given two very important clues, one bein g the fact the device (video card) show up in DM with a ? , this means there is a conflict of some kind. The second clue was the switching of the cables, so the monitor is ruled out. It must be the video card for the seconnd monitor.

One of the first things I would check is the resources assigned to that device, I would say that the I/O memory range is conflicting here. I have had this happen as well.

In DM you can goto the view menu and select view by resources or connection, this will also give you info on the state of each resource.

Im betting that it is here you will find your problem.

Good Luck.

by dmiles

are the two cards the same,using PCI in one slot and AGP in the other will cause a conflict whereas the primary computer card will over ride the secondary card,one the card drivers may not be Win2k compatible or the card is not supported in win2k.

This discussion is closed to new replies.