6 replies
by acbell40 Accepted solution
by w2ktechman Accepted solution
The code for your copy is not stored on the CD, there was a sticker with the cd-key on it that is needed. If you are the valid owner, call MS and they can assign a new key for you.
If you are not the owner, and are just looking for a crack, then read my next post.
by w2ktechman Accepted solution
First, I need to mention that this is the worst route, and I only supply this as informative, not to actually be utilized.
DO NOT ATTEMPT THIS as it is illegal and immoral. Please read my original post first and be sure that this is the post you want to read...........
Ok, you have decided to 'Learn' about cracking a CD Key for MS Office. You will need a few pieces of HW to get started.
Small or medium sized hammer
3" long nail or metal pipe
grounding wire
screwdriver (philips)
screwdriver (flathead)
Ok, to start, once you have assembled the equipment listed, you will need to open up the computer. Look for the HDD and pull it out of the box.
On the outer circle (where the platters lay underneath) use the hammer (lightly, very lightly) until the top of the HDD is dented, just a little (1/4 inch deep max). If you ding it too far, you need a new HDD. If you dont ding it enough, you have to start all over again.
Re-insert it into the computer after checking for proper depth of the ding. DO NOT POWER ON THE COMPUTER YET, as this may cause unexpected errors.
Tie the grounding wire around your arm, leg, neck, etc.. Wherever is most comfortable to continue working. Make sure you have it on well, and not loose. The connection needs to be good.
Plug the computer in but do not boot it up, you will need to do a quick short through the circuit. For best results, you will need to draw a little blood (dont worry, it only hurts for a few seconds. Trust me, the results just cant be beat by it though. But this is not mandatory, so this can be skipped if needed.
Optional -- best results -- Ok if you choose this route, use the 3-inch nail and hammer, place your foot near the power supply of the computer or notebook. Turn the power on the unit. Before it gets to Windows, in the center of your foot, find the opening between bones (you dont want to break a bone, cause that would hurt), hit the nail really hard to make sure that the nail provides the blood to the power supply for the ultimate connection, and the nail goes through the power supply correctly. You may feel a slight buzz, this is normal. Also gives you a new 'high' that is not illegal.
Other route -- Since you decided against the nail in the foot, this is the next best route. MS DOES NOT WANT YOU TO KNOW THIS (or even to do it).
take the small pole, and tape it to your hand. An iron rod works fine. At least 3-6 inches should be plenty.
Please it by the power supply gently. Turn on the unit and then pound the iron rod with the hammer, into the power supply.
you dont get the same 'high' as the other route, but you may feel a quick jolt, but thats it. Sometimes people report that they didnt even get the jolt.
Whichever path you chose, the Office CD should auto-install and it WILL NOT ask for either the cd-key OR validation.
it is a WIN WIN situation.
by w2ktechman Accepted solution
This discussion is closed to new replies.
Trending Software posts
Sort by Trending