Discussion Locked

Properties of the Network corrupt

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Via the Control Panels "Network" I go to "Protocols" en try to open the TCP/IP Properties. Then I get an errormessage "An error occured While window was working with the Control Panel file C:\WINNT\SYSTEM32\NCPA.CPL.
I already replaced the old one with expand d:\i386\ncpa.cp_ c:\winnt\system32\ncpa.cpl with the same result.

4 replies

by sgt_shultz

well, i have to put a quarter in the box, but
that should have worked.
are you quite positive you have successfully replace the file? did you check file sizes and dates before and after or notice that you got a prompt warning you that you were going to overwrite the existing file file?

by simbn

Try remove the network card, restart your system and install back again. Makesure you are using the correct driver for your card.

This discussion is closed to new replies.