Discussion Locked

QPS DVD

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm trying to install a QPS DVD on my Compaq ML370 Server. I can't get it to work. Has anyone had this problem?

3 replies

by gregory pleau

If you are trying to play dvd movies on NT4 you can stop now. It's generally not supported. If you're just trying to get the thing up for data access, the usual applies.

Make sure the ide (atapi) driver is loaded if this is the only ide drive in the system (control panel / scsi). Same goes if this is a SCSI drive, make sure the controller card is installed in the scsi applet of the control panel.

Also, check your drive to make sure it is not conflicting with another device. If IDE the drive should be Slave and the other device Master (if anything else is on the cable). If SCSI, make sure it is using a different SCSI ID than the other devices.

Another handy trick for IDE/ATAPI drives is to use a Windows boot disk to validate that the system can actually see the drive before trying to battle NT's SCSI subsystem.

Good Luck

This discussion is closed to new replies.