Discussion Locked

RAID or not.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi you may think this is simple but I am trying to mirror my IBM servers disks.I think I have succeeded but how the hell do you know for sure.Is there some test I can do to verify that the second disk would in fact take over after failure.
I copiedsome sytem files (boot.ini,ntdetect,ntldr)to a floppy edited the boot.ini to reflect the mirrored disk and rebooted using the floppy.It does'nt boot which is good (I think)but I really need to know if it will take over after primary disc failure.
Does it auto take over or is there some work to be done beforehand.Any help appreciated, & thanx for your time.

5 replies

by tigre_269

Are you implementing NT software RAID or hardware RAID?

To test an NT software mirror set, remove one of the drives WITHOUT breaking the mirror within NT Disk Administrator. If you break the mirror in Disk Administrator, NT will assign the disk removed from the mirror set sequential drive letters.

For, ex. If you have C:, D: mirrored, after breaking the mirror, your second disk would be E:, F:. Though that disk is a mirror of your boot disk, the drive letter assignment would prevent it from booting up. I would reccommend doing this with the server powered down. I've only tried this with non-pluggable drives, so I had no choice. Before doing any testing, I recommend haveing an image of your system.

If you implemented hardware RAID, it would be transparent to NT. NT would only see it as one disk. If you have the budget, I highly recommend hardware RAID over NT software RAID. Here are a couple of links, hope this helps.

http://www.acnc.com/raid.html

You need to scroll down a little on this one. It compares hardware RAID vs. Software RAID
http://www.microsoft.com/TechNet/win2000/planning.asp

by estebandelatorre

You have a disk mirrored by NT software no?
Verify in event log that the mirror is fine.
Simply unplug one power supply disk and see what happens...
It must post an error to the event log, and the server should keep on working fine.
Afterhours, plug the power again (everything powered off), and boot again, the disk will auto mirror again.

This discussion is closed to new replies.