Hardware
MY computer is running on p4 1.7GHZ processor with
mercury mother board using intel 845gl as chipset.I am using 128mb SDRAM having 133MHZ and i recently bought a new 256mb DDR RAM having 266MHZ when i installed it on my computer it is not booting (i onstalled DDR after removing SDRAM). pls send me a solution
by dustyd
Not familiar with your board, but check bios to see if you need to set your memory type and speed. FSB should remain at 400mhz.
Also check to see if you must install in pairs.
Common memory problems are modules not seated fully. Remove and reseat carefully.
How many chips does your old memory have? Odd number of chips on a board will indicate ECC type memory. Even number indicates non-ECC memory.
by willcomp
First question is: does your motherboard support DDR RAM? Apparently you ogiginally had SDRAM installed. DDR should not fit in an SDRAM slot due to keying.
Dalton
by willcomp
by glyall
If I remember right SDRAM and DDR Ram do do mix.
Use only SDRAM or DDR Ram not both on the same motherboard.
go to the motherboard site and check the info and setup documention for your MB
good luck
This discussion is closed to new replies.
Sort by Trending