Discussion Locked

RAM Upgrade question

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
For further clarification, I am adding a 64Meg ram module to my existing 64Meg; the new one is a 133 mhz SDRAM DIMM 168 pin; my existing one is a 100Mhz SDRAM DIMM 168 pin..does the 133 have to go into the FIRST RAM slot or can it go into the currently empty 2nd slot...will the BIOS detect it in the 2nd slot?

7 replies

by dpalsen

Assuming the board is a 100MHz Front Side, you'll probably not have any problem. If it's one of the older 66MHz, I've never been able to stabilize a 133MHz DIMM in one. It sounds like you may have already bought the RAM and are having problems? Assuming this, just pop it in and try it. It won't hurt the Motherboard any.

by ð

check the user's manual for ur motherboard and make sure it's supports PC133. PC133 will not work with PC100, u can only use either or not both. Dont recommend to mismatch memories they always cause problems. always use the same make/type of RAM.

by bratlady

I agree with #1, just try it in the second slot. Your BIOS will see it if it's acceptable to the system. But, just in case that doesn't work, or in case your system behaves strangely, I'd try switching the 2 modules to where the fastest is in the first slot. You never know how some systems will accept RAM, especially with different brands & timings....

This discussion is closed to new replies.