Discussion Locked

RAS: Dial out and Receive Calls

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
does setup RAS on W4S+SP6 in 'Dial out and Receive Calls' mode. All works fine until anyone connect to me. After that when i try establish dial-out connection NT says ...port not configured for dial out...

2 replies

by gmcnslt

sounds like your port isn't dropping the carrier, or returning it to a ready state.. what kind of modem do you use?

by psv

i'm using TAINET 336Cx. line dropped because i can connect to my server again. after reboot all works fine already.

This discussion is closed to new replies.