but only up to the 2TB MBR limitation
previous versions of these disks shipped pre-formatted to FAT32
I know someone who has two of them in the 2TB size
here's the current partition Properties dialog: (only one partition)
http://i832.photobucket.com/albums/zz249/WhatNameShoudIUse/2TBDeathStar.png?t=1296376414
I have a couple of tools in the kit to do this:
a> Backup Exec System Recovery
- Copy Drive tool (select a small FAT32 drive to clone)
- check Resize drive to fill unallocated space *(up to 1TB in size)
or
- Recover from an image of a FAT32 drive of any size
- check Resize drive to fill unallocated space *(up to 1TB in size)
*(it's a programmed limitation that it won't expand beyond 1TB when cloning a smaller drive and expanding it to fill unallocated space)
b> by far the quickest method is to use FAT32Format.exe command line formatter
or the GUIFormat.exe Dialog box version *(up to the Max. 2TB Limit)
the link to the site where the command line formatter is located,
is on the HitachiGST site under the FAQ for,
[b]External Drive Troubleshooting Steps[/b]
here: http://www.hitachigst.com/support/index-files/general-faqs-index
and on the site for the command line format tool is also a link to the GUIFormat tool
currently the disk is spinning and operating under I/O load
with the repeated copying files on the disk to the same with new file names
and it is stone cold,
not even the slightest bit of detectable heat coming off of it
because I have a 38v 90mm fan blowing at full blast across the vent holes
the only way it could be cooler is if I stuffed it in the fridge or freezer
I do this with all my disks, internal and external
ie.
all my e-SATA disks are installed into Thermaltake Max4 enclosures
which have an 80mm x 15mm fan pushing air directly onto the drive from the PCB side
all my internals have some sort of fan pushing air across the disks
I know that heat kills
but so does unnecessary stop / start cycles
I go out of my way to cool things
so I'd rather this disk spin the whole time it's powered up
because the unnecessary spin down spin up counts
will kill it long before anything else will
ie.
do the same with a car
shut it off and start it up again at every stop sign, red light, etc.
also shut it off at the top of hills and coast down restarting at the bottom
- and see how long the starter lasts
not to mention all the other things that will eventually blow up doing this
it only spins when it's plugged in and accessed for I/O
as soon as the I/O stops, less than 5 minutes goes and it shuts off
the strange thing here is that it didn't do this on the first day I used it
it powered up fully just upon plugging in the power
and it stayed spinning for over an hour after the copy script was done
(at which point I shut the whole system down and went to bed)
now it won't do anything until the USB cable is plugged
I tested the wall wart and it's giving a full 12 v
I may test my old P-4 workstation USB port to see if the Hitachi Feature tool can see the drive
everything else can
it has a weird BIOS,
when you plug a disk in before powering up the system it adds the first USB Mass storage device it finds to the list in the BIOS and allows it to be seen by things like Seatools or SpinRite,
but I haven't tested the Hitachi tools yet